Clippasafe 70/5 Socket Protector User Manual download pdf

IMPORTANT - READ INSTRUCTIONS CAREFULLY

AND KEEP FOR FUTURE REFERENCE

Socket Protector

Instructions for Installation and Use

TOOLS REQUIRED - Insulated screwdriver

ELECTRICAL SAFETY

This product is designed to be used with BSI approved UK style three pin electric wall mounted sockets,

switched or unswitched. It is not suitable for use with surface mounted pattress boxes or for use outdoors.

There is no need to disconnect the mains supply, so long as the Socket Protector is used with a correctly

maintained BSI approved double or single wall socket.

When working near electricity always take good care. If in any doubt consult a qualified electrician.

Installation

1. Select the wall socket

you intend to protect,

power off the switches

and remove any plugs in

use. Loosen the screws

on the socket faceplate

until a gap of 4mm, or as

much as is needed to

allow the Socket Protector

frame to slide in between

the faceplate and the wall.

2. Slide the upper part of

the Socket Protector

frame down between the

wall and the socket

faceplate.

3. Ensure that the lugs

in the top of the Socket

Protector frame slide

fully down behind the

top edge of the socket

faceplate.

4. Keeping the lower part

of the frame in position,

slide the bottom part of

the Socket Protector frame

up between the wall and

the socket faceplate.

Guide the side walls into

the locking mechanisms

on each side of the top

frame ensuring that a

portion of the bottom lugs

fit behind the faceplace.

5.Close the top and

bottom frames together

until both side catches

click and lock into place.

For many socket faceplates

the Socket Protector may

appear slightly oversized,

however the Socket

Protector is designed to

accommodate all faceplates

including the largest

currently available.

6. Retighten the screws

on the socket faceplate.

Ensure that the Socket

Protector frame is secured

firmly all round between

the wall and the socket

faceplate.

7. Check that the Socket

Protector closes and

locks. If not, loosen the

faceplate screws, check

that the top and bottom

parts of the frame are

firmly locked together,

and adjust the position of

the frame between the

wall and socket faceplate.

Then retighten the screws.

8. To open the Socket

Protector, press the

buttons on each side

and raise the front cover.

3 4

6 8

1 2

Socket Protector 1
Troubleshooting 2

Summary of Contents

Page 1 - Socket Protector

IMPORTANT - READ INSTRUCTIONS CAREFULLYAND KEEP FOR FUTURE REFERENCESocket ProtectorInstructions for Installation and UseTOOLS REQUIRED - Insulated sc

Page 2 - Troubleshooting

CLIPPASAFE MODEL No.70/5©Clippasafe Ltd 2010 - 70/5/Mar2010Clippasafe Ltd.,Lanthwaite Road, Clifton,Nottingham. NG11 8LD. England.Fax: 0115 984 5554E-